This is a create a card die so cuts into the front of your card.
No matter what I do this die won't cut properly. I have done 8 passes and still the top and bottom of the die won't cut.
Has anyone had any success with this die or is it just me ?
This is a create a card die so cuts into the front of your card.
No matter what I do this die won't cut properly. I have done 8 passes and still the top and bottom of the die won't cut.
Has anyone had any success with this die or is it just me ?
I have one of the die'sire create a card dies
I had the same problem
Tried it in the X cut turning each time it goes through
Extra shim it still did not cut through some parts ended up having to cut missing bits with a
craft knife till in the end bits of the die cracked from all the
passes through the machine
Post Thanks / Like - 1 Thanks, 0 Likes1 Member(s) thanked for this postYou don't have to be as mad as a box of frogs to be here but it helps:mysmilie_13:
I don't have them but I've seen CC doing a dem on Hochy and they had terrible trouble getting them to release and poking the bits out - ended up asking the presenter to help, all done jovially of course "because they were rushing" but I knew you'd had trouble with yours Deefy......wonder if its the whole of that particular design set? Maybe if you both contact Sara she'd be able to help?
Post Thanks / Like - 1 Thanks, 0 Likes1 Member(s) thanked for this post
My die cuts ok on Linda's Black Cardstock but the second I use what I would normally use as a special Cardstock (Anne Marie Gold 8 X 8) no way will the top and bottom of the die actually cut. I can't rotate it either because of the size.
Massive shame as it is a beautiful die.
You could be right Deefy about which set it is but I bought it as a single die.
Wondering if I should go for an electronic machine as I am using the GC.
Last edited by Julie; 15-09-2016 at 05:32 PM.